Enhance-d reads your data from your Polar account rather than from the device itself, so whatever reaches Polar reaches Enhance-d. Nothing is installed on the device.
Once it is connected, Enhance-d receives your workouts, sleep and steps.
Connect Polar
- Open Enhance-d and go to Settings.
- Under Integrations, tap Manage integrations.
- Find Polar in the list and tap it.
- A screen appears headed Connect to Polar. Tap Continue.
- A browser window opens on Polar's own sign-in page. Sign in and allow the connection.
- You are returned to Enhance-d, which confirms Successfully connected to Polar.
Your data will not appear straight away. Give it a few minutes - the first sync has to be fetched before it can show up anywhere in the app.
Enhance-d never sees your Polar password - you type it on their site, not ours.
Which devices this covers
36 watches, trackers, sensors and bike computers, including Vantage M3, Vantage V3, Vantage V2, Vantage M2, Vantage V, Vantage M, Grit X2 Pro, Grit X2 Pro Titan, Grit X2, Grit X Pro, Grit X and Pacer Pro - and others. The full list is on the product site.
If you also connect another route in
Records are stored against the connection they arrived through. So if the same workout reaches Enhance-d twice - once from Polar, and once from Strava or a phone health app that Polar also feeds - it appears twice, because the two copies arrive as separate records and cannot be matched to each other.
If you are seeing everything doubled, that is almost always why. Disconnect whichever route you want less, and keep one.
If it will not connect
- Check you are not at the free limit. In Manage integrations the banner reads "X of 3 Free integrations connected". At three, tapping a new one brings up an upgrade prompt rather than the connection, which can look like a failure. Disconnect one you no longer use, or upgrade.
- Make sure Enhance-d is up to date, then force-close it and open it again.
- Try once more. The connect step reaches out at the moment you tap it, so a dropped connection ends it early.
- If you are signed into more than one Polar account, sign out of Polar in your phone's browser first, so you are not authorising the wrong one.
Still stuck? Message us and say which phone you are on and how far you got. That tells us which half of the connection to look at.
Disconnecting
Go to Settings → Manage integrations, tap Polar, and disconnect. Data already in Enhance-d stays where it is; nothing new arrives after that.