Enhance-d reads your data from your InBody account rather than from the device itself, so whatever reaches InBody reaches Enhance-d. Nothing is installed on the device.
Once it is connected, Enhance-d receives weight and body composition.
Connect InBody
- Open Enhance-d and go to Settings.
- Under Integrations, tap Manage integrations.
- Find InBody in the list and tap it.
- A screen appears headed Connect to InBody. Tap Continue.
- A browser window opens on InBody's own sign-in page. Sign in and allow the connection.
- You are returned to Enhance-d, which confirms Successfully connected to InBody.
Your data will not appear straight away. Give it a few minutes - the first sync has to be fetched before it can show up anywhere in the app.
Enhance-d never sees your InBody password - you type it on their site, not ours.
Which devices this covers
InBody Dial H40, InBody Dial H30, InBody Dial H20, InBody H20N and InBody BAND 2.
If it will not connect
- Check you are not at the free limit. In Manage integrations the banner reads "X of 3 Free integrations connected". At three, tapping a new one brings up an upgrade prompt rather than the connection, which can look like a failure. Disconnect one you no longer use, or upgrade.
- Make sure Enhance-d is up to date, then force-close it and open it again.
- Try once more. The connect step reaches out at the moment you tap it, so a dropped connection ends it early.
- If you are signed into more than one InBody account, sign out of InBody in your phone's browser first, so you are not authorising the wrong one.
Still stuck? Message us and say which phone you are on and how far you got. That tells us which half of the connection to look at.
Disconnecting
Go to Settings → Manage integrations, tap InBody, and disconnect. Data already in Enhance-d stays where it is; nothing new arrives after that.