Search help

How to connect Glooko

Connecting Glooko to Enhance-d, and what comes across once you have

Written by Henry · Updated 18 September 2026 · 2 min read
Print or save as PDF

Your phone talks to Glooko directly and passes the readings on. Your Glooko sign-in is kept in your phone's secure storage, not on our servers, and the sync carries on in the background while the app is closed.

Once it is connected, Enhance-d receives glucose readings, insulin doses and what you ate.

Connect Glooko

  1. Open Enhance-d and go to Settings.
  2. Under Integrations, tap Manage integrations.
  3. Find Glooko in the list and tap it.
  4. Read the note explaining that this one runs on your phone, and continue.
  5. Enter your Glooko details on the screen that follows and save.
  6. The first sync starts straight away. Leave the app open for a minute while it catches up.

Your data will not appear straight away. Give it a few minutes - the first sync has to be fetched before it can show up anywhere in the app.

This is an unofficial integration: it uses Glooko's own service the way their app does, rather than a partnership with them. If they change something at their end it can stop until we catch up.

Which devices this covers

Omnipod 5, Omnipod DASH, Contour Next One, Accu-Chek Guide, Accu-Chek Instant, OneTouch Verio Flex and OneTouch Verio Reflect.

Omnipod 5 and CamAPS FX

Neither has a direct connection to Enhance-d. Both reach us through Glooko: connect your pump or closed-loop system to Glooko as its own instructions describe, connect Glooko here, and the data follows.

If it will not connect

  1. Check you are not at the free limit. In Manage integrations the banner reads "X of 3 Free integrations connected". At three, tapping a new one brings up an upgrade prompt rather than the connection, which can look like a failure. Disconnect one you no longer use, or upgrade.
  2. Make sure Enhance-d is up to date, then force-close it and open it again.
  3. Try once more. The connect step reaches out at the moment you tap it, so a dropped connection ends it early.

Still stuck? Message us and say which phone you are on and how far you got. That tells us which half of the connection to look at.

Disconnecting

Go to Settings → Manage integrations, tap Glooko, and disconnect. Data already in Enhance-d stays where it is; nothing new arrives after that.

Did this answer your question?